Expansion Systems: Dataflyer Express
Connection: Seitlicher Expansion Slot

Picture showing the whole unit. Please note, the edge connector in this picture has been replaced
Picture showing the whole unit. Please note, the edge connector in this picture has been replaced

Picture showing the rear of the unit showing the DB25 SCSI Connector and Power Connector
Picture showing the rear of the unit showing the DB25 SCSI Connector and Power Connector

Picture showing inside the unit
Picture showing inside the unit

Chips, labelled from left to right (in middle of board) DECODE 1.0 (in socket U14) RASCAS 1.0 (in socket U15) DFS PAL (in socket U16)
Chips, labelled from left to right (in middle of board) DECODE 1.0 (in socket U14) RASCAS 1.0 (in socket U15) DFS PAL (in socket U16)

Dataflyer Express Diagrams - 87K

(far right of board) DF AUTOBOOT VERSION 2.0 (in socket U24) -- this version shipped with original Express models. (Could be upgraded with the version 2.1 TT chip used in later DF 500 models as well -- this ROM is on board)

The controller chip below the autoboot ROM is made by AMD.

The pictures show the SCSI only version of this unit, but the three empty slots on the board are for adding the IDE controller

The Dataflyer Express came in three different flavours, IDE Only, SCSI Only and both IDE and SCSI. It also had 8 x 30pin SIMM sockets for up to 8MB of additional RAM and could accept both 1MB and 256k SIMMs. The SIMMs must be added in pairs. The unit PCB itself may have been simply a Zorro II card fitted in the a box designed to fit the expansion socket of the A500 using the female edge connector, because it could be removed and placed in an A2000. The Dataflyer Express would also take advantage of the Baseboard if it was installed.

Contributions to this page by:
Christopher Smith


Einem link gefolgt? Hier gehts zur Hauptseite

Followed a link? Please go to the Main Site